Owner's Manual
Table Of Contents
- Instruction Manual
- Highlights of the Camcorder
- Table of contents
- 1. Introduction
- 2. Preparations
- 3. Recording
- Recording Clips and Photos
- Video Configuration: Resolution, Bit Rate and Frame Rate
- Slow & Fast Motion Recording
- Shooting Modes
- Exposure Adjustment
- Automatic Gain Control (AGC) Limit
- White Balance
- Using Looks
- Zooming
- Focus Adjustment
- Image Stabilization
- Setting the Time Code
- Setting the User Bit
- Recording Audio
- Selecting the Audio Recording Format
- Audio Settings and Recorded Audio Channels
- Connecting an External Microphone or External Audio Input Source to the Camcorder
- Using Line Input or an External Microphone Connected to an INPUT Terminal
- Audio Recording Level (INPUT Terminals)
- Adjusting the Microphone’s Sensitivity (INPUT terminals)
- Microphone Attenuator (INPUT terminals)
- Using the Built-in Microphone or an External Microphone Connected to the MIC Terminal
- Audio Recording Level (Built-in Microphone/MIC Terminal)
- Microphone Sensitivity (Built-in Microphone)
- Microphone Attenuator (Built-in Microphone or MIC Terminal)
- Low-Cut Filter (Built-in Microphone or MIC Terminal)
- Using Headphones
- Color Bars/Audio Reference Signal
- Pre-Recording
- Onscreen Displays
- Infrared Recording
- Using the Optional RC-V100 Remote Controller
- Using the GP-E2 GPS Receiver
- 4. Customization
- 5. Playback
- 6. External Connections
- 7. Saving Clips
- 8. Additional Information
- Quick Guide
- Important Usage Instructions
- Precautions About the Battery Pack
- Supplied Accessories
- Table of Contents
- Names of Parts
- Charging the Battery Pack
- Basic Preparations
- Setting the Date, Time and Language
- Using SD Cards
- Recording Clips and Photos
- Playing Back and Saving Clips and Photos
- Connecting to an External Monitor
- Onscreen Icons and Displays
- Safety Instructions and Handling Precautions
- Others
- Abridged Specifications
- Additional Information
- Warranty
Recording Audio
73
Microphone Attenuator (INPUT terminals)
When one of the audio channels is set to the INPUT terminals and the corresponding sensitivity
selection switch is set to MIC or MIC+48V, you can activate the external microphone’s attenuator
(20 dB).
1 Select the desired INPUT terminal’s sensitivity.
> [C ! Audio Setup] > [INPUT 1 Mic Att.] or [INPUT 2 Mic Att.]
2 Select [i On] and then select [X].
• å appears at the right of the screen.
Using the Built-in Microphone or an External Microphone Connected to the
MIC Terminal
If the handle unit is attached to the camcorder but you will not
connect an external microphone to an INPUT terminal, follow the
step below to use the built-in microphone or an external
microphone connected to the MIC terminal. When an external
microphone is connected to the MIC terminal, the camcorder will
switch automatically from the built-in microphone to the external
one.
Set the INPUT terminal ON/OFF switch to OFF.
• If you connect a microphone to the MIC terminal, the
camcorder will switch automatically from the built-in
microphone to the external microphone.
To use a commercially available plug-in power microphone
1 Select [MIC Power].
> [¡ # Audio Setup] > [MIC Power]
2 Select [i On] and then select [X].
IMPORTANT
• Supplying power to a microphone without plug-in power functionality may damage the microphone.
Adjusting the L and R channels of the MIC terminal independently
You can use the > [¡ Audio Setup] > [MIC ALC Link] setting to separate the audio
level adjustment for the L and R channels of an external microphone connected to the MIC
terminal, allowing each channel to be adjusted independently.