Owner's Manual
Table Of Contents
Using the Image Stabilizer
•
To
use
image
stabilization,
set
the
Image
Stabilizer
to
ON.
The Image Stabilizer settings are explained below.
□
EF
(EF-S)
lenses
and
RF
lenses:
Use
the
Image
Stabilizer
switch
on
the
lens
(ON/OFF).
□
EF-M lenses: Select
the
setting on
the
camera ([ON/OFF]).
Attaching a Lens Hood
Align the hood with the edge
of
the lens and turn the hood
clockwise to attach it.
Using the Control Ring
This only applies
to
RF lenses equipped with a control ring.
Refer to the camera's instructions for information on using the
control ring.
Nomenclature
G) Lens mount index
® Focus mode switch
@ Focusing ring
@Zoom
ring
® Image stabilizer switch
@ Image stabilizer mode selector switch
MODE
1:
Corrects vibrations in all directions.
MODE 2: When you take a panning shot either horizontally or
vertically, corrects vibrations at right angles to the
direction
of
panning.
MODE 3: Corrects vibration only during exposure.
(j) Focusing distance range selector switch
Selects the focusing distance range.
@Tripod mount (fixed-mount type)
Used
to
attach a tripod
or
monopod.
®Tripod
mount (detachable tripod type)
Used
to
attach a tripod
or
monopod.
@)
Lens-retraction switch
Push the switch in the
..
.._,,
direction while turning the ring to set
the lens to the ready position.
@ Lock release switch
Push the switch in the
..
.._,,
direction while turning the ring
to
set
the lens to the ready position.
@ Macro Lite ON button
Used
to
change the Macro Lites illuminated patterns.
@ Macro Lites
Illuminate the subject
@Lens
cap
@Dust
cap
@ Hood (bayonet type)
@ Hood (screw type)
@ Control ring
CD
®
®
®
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Do not make any changes or modifications to the equipment unless otherwise specified in the instructions. If
such changes
or
modifications should be made, you could be required
to
stop operation of the equipment.
This equipment has been tested and found
to
comply with the limits for a class B digital device, pursuant to
part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one
or
more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult the dealer
or
an experienced radio/TV technician for help.