User Manual

485
Troubleshooting Guide
Remote control shooting is not possible.
z
When taking still photos, set the drive mode to [
Q
] (
=
137). When
recording movies, set [
z
: Remote control] to [Enable] (
=
237).
z
Check the position of the remote control’s release timing switch.
z
If you are using Wireless Remote Control BR-E1, see
=
193,
=
389.
A white
s
or red
E
icon is displayed during still photo shooting.
z
It indicates that the camera’s internal temperature is high. Image quality
of still photos may be worse when a white [
s
] icon is displayed. If the
red [
E
] icon is displayed, it indicates that the shooting will soon stop
automatically (
=
194).
During movie recording, the red
E
icon is displayed.
z
It indicates that the camera’s internal temperature is high. If the red [
E
]
icon is displayed, it indicates that the movie recording will soon stop
automatically (
=
242).
[ ] is displayed.
z
[
] may be displayed after repeated movie recording, or if you keep the
camera standing by for movie recording over extended periods (except
when set to
L6
/
L5
).
The camera turns o󰀨 automatically in approx. 3 min. if you continue
recording while [
] is displayed. The camera may also turn o󰀨
automatically while standing by for movie recording when [ ] is
displayed. Turn o󰀨 the camera when [ ] is displayed, and wait to allow
the camera to cool down.
z
The date/time/zone must be set to enable normal camera temperature
control. Once the date/time/zone are set, temperature warnings can be
displayed correctly.
z
If [Overheated! Shutting down.] is displayed, turn o󰀨 the camera and
wait at least 3 min. Note that the camera should be o󰀨 for 9 min. or more
if you will record a 4K movie up to 9 min. 59 sec. or a high frame rate
movie up to 7 min. 29 sec. (Actual movie recording times may be shorter,
depending on the recording environment and conditions of use.)