User Manual

Preparing Recording Media

Inserting and Removing an SD Card

1 Wait until the SD CARD access indicator is off or is

illuminated in green.

2 Slide the card compartment cover switch all the way in

the direction of the arrow.

• The card compartment cover will open to the left.

3 Insert the card straight, with the label facing the back

of the camera (the side with the battery compartment)

all the way into the SD card slot until it clicks.

• To remove the card, make sure the SD CARD indicator is

off and then push the card once to release it. When the

card springs out, pull it all the way out.

4 Close the card compartment cover.

• Do not force the cover closed if the card is not correctly

inserted.

SD card access indicator

If you set > [

System Setup] > [SD Card Access LED] to [Off], the SD card access indicator will not

illuminate.

IMPORTANT

• SD cards have front and back sides that are not interchangeable. Inserting a card facing the wrong direction

can cause a malfunction of the camera. Be sure to insert the card as shown in the illustration.

SD CARD indicator SD card status

Red Accessing the card.

Green

CAMERA mode: Proxy clip recording is activated and the card is ready for recording.

MEDIA mode: Playback from the card is possible.

Off

• A card is not inserted in the camera or the card is write-protected.

• CAMERA mode only: A card is inserted but proxy clip recording is not activated.







SD CARD

indicator