Owner's Manual

Using Wireless Flash tr
I!:II !1111!]111ii :::n::mlii !III! OJ:: .:
:: iii
lili J: .ii j
Fully Automatic Shooting with One External Speedlite
Indoors
Outdoors"············
__ 1_0 :e-:Approx. 10m
(32:8ft. )
This shows the most basic setup
for fully-automatic wireless flash
with one Speedlite.
Steps 1 to 3 and 6 to 8 apply to
all wireless flash shooting.
Therefore, these steps
are
omitted in the other wireless
flash setups explained
on the
following
pages.
On the menu screens, the < ;-. >
and < -. > icons refer to the external
Speedlite, and the < ;~ > and < ~ >
icons refer to the built-in flash.
Quality (J,,!J+.l
Red-eye On/Off Off
Beep On
Release shutter without card
Review ti me 2 sec.
Peripheral iIIumin. correct.
Flash control
Flash control
Flash firing Enable
Built-In flash func. setting
Built-in flash func. setting
Flash mode E- TTL II
Shutter sync. 1 st curtain
~exp. compo -L2 .. 1..~ .. 1..2.~3
120
1 Press the < ~ > button to pop-up
the built-in flash.
~ For wireless flash, be sure to pop-up
the built-in flash.
Select [Flash control] .
. ~ Under the [~.] tab, select [Flash
control], then press < @ >.
3 Select [Built-in flash func. setting].
~ Select [Built-in flash func. setting],
then press < @ >.
Select [Flash mode].
~ For [Flash mode], select [E-TTL II],
then press
< @ >.