Owner's Manual

Built-in flash func. setting
Shutter sync. 1st curtain
E- TIL II Evaluative
Wireless func. ;If..
Channel 1 ch
Firing group -.(AfB+C)
mJ2J Clear flash settings
EaI Test flash firing
Built-in flash func. setting
E- TIL II Evaluative
Wireless func. ~-.
Channel 1 ch
Firing group -.(A+B+C)
mIM Clear flash settings
~Test flash firing
Using Wireless Flash *
5 Select [Wireless tunc.] .
• For [Wireless tunc.], select [~ .. ],
then press < @ >.
~ Under [Wireless tunc.], [Channel],
etc., will be displayed.
Set [Channel].
• Set the channel (1-4) to the same one
as the slave unit.
Fire a test flash.
@ After checking that the slave unit is
ready to fire, go to the screen in step I
5 and press the < ~:~ > button.
~ The slave unit will fire. If it does not
fire, check your settings again
(p.119).
Take the picture.
~ Set the camera and take the picture
as you would with normal flash
shooting.
~ To terminate wireless flash shooting,
set
[Wireless func.] to [Disable].
Eil $ Test flash can also be used to wake up slave units from auto power off.
$ Setting [E-TTL II] to [Evaluative] is recommended.
• If you use only one external Speedlite, the
[Firing group] setting does
not have any effect.
~ The slave unit is controlled by the built-in flash's light pulse signal.
* Wireless flash will not work if the [Flash mode] is set to [MULTI flash].
121