Owner's Manual

-- Notes on Movie Shooting
Recording and Image Quality
elf the attached lens has an Image Stabilizer, the Image Stabilizer will
operate at all times even
ify6u do not press theshutterbutton halfway.
The Image Stabilizer may cause the total movie shooting time or the
number
of possible shots to decrease. If you use a tripod or if the Image
Stabilizer is not necessary, you should
set the IS switch to <OFF>.
• The camera's built-in microphone will also pick up camera operation
noise. If you use a commercially-available external microphone, you can
prevent (or reduce) these noises from being recorded.
• Do not connect the external microphone IN terminal to anything other
than
an external microphone.
• Autofocusing during movie shooting is
not recommended since it might
momentarily throw the focus way off or change the exposure. Even if the
AF mode has been set to
[Quick mode], it will switch to the Live mode
during movie shooting.
s If movie shooting
is not possible due to the insufficient remaining
capacity
of the card,. the movie shooting remaining time (p.152) will be
displayed
in red.
elf you use a card having a slow writing speed, a five-level
indicator might appear on the right
of the screen during
movie shooting. ltindicates how much data has not yet been
written to the card (remaining capacity
of the internal buffer
memory). The slower the card, the faster the indicator will
climb upward. If the indicator becomes full, movie shooting
will stop automatically. Indicator
If the card has a fast writing speed, theindicator will either
not appear
or the level(if di$played) will hardly 90 upw~rd.
First, shoola few test movie's to see if the card can write fast enough~
If you take still photos during the movie shooting, the movie shooting
might stop. Ifthe still image recording quality has been set low, the movie
shooting might continue instead.
eWhenmovieshootiriglsset,certainCusfom.Function •• settings·will·be
disabled (p.205).
158