Owner's Manual

Error Codes
Error No.
I
I
Countermeasures
If there is a problem with the camera, an
error message will appear. Follow the on-
screen instructions.
No. Error Message & Solution
Communications between the camera and lens is faulty. Clean the
lens contacts.
01
-+ Clean the electrical contacts on the camera and lens and use a
Canon lens. (p.13, 16)
Card cannot be accessed. Reinsert/change card or format card
with camera.
02
-+ Remove and install the card again, replace the card, or format the
card
(p29, 43).
Cannot save images because card is full. Replace card.
04
-+ Replace the card, erase unnecessary images, or format the card
(p.29,
179,43).
The built·in flash could not be raised. Turn the camera off and on
05
again.
-+ Operate the power switch (p.27).
06
Sensor cleaning is not possible. Turn the camera off and on again.
-+ Operate the power switch (p.27).
10,20,
Shooting is not possible due to an error. Turn the camera off and
30,40,
on again or re-install the battery.
50,60,
-+ Operate the power switch, remove and install the battery pack
70,80
again, or use a Canon lens (p.27, 26).
•
If the error still persists, write down the error No. and contact your nearest I
Canon Service Center.
249