Owner's Manual

7 I '\
~ I t.
P: Program AE
• If the "30"" shutter speed and the maximum aperture
blink,
it indicates underexposure.
Increase the ISO speed
or use flash.
•
If the"8000" shutter speed and the minimum aperture
blink, it indicates overexposure.
Lower the ISO speed
oruse an NO filter (sold
separately) to reduce the amount
of light entering the
lens.
~
LjI Differences Between<P> and <0> (FullAuto)
With <0>, many functions such the AF mode,drive mode, and built-in
flash are set automatically to prevent spoiled shots. The functions you can
set are limited. With
<P>,only the shutter speed and aperture are set
automatically. You can freely set the AF mode, drive mode, built-in flash,
and other functions (p.236).
About Program Shift
• In the Program AE mode, you can freely change the shutter speed and
aperture combination (Program) set by the camera while maintaining the
I
same exposure. Thisis.called Program shift
• To do this, press the shutter button down halfway, then turn the <~>
dial until the desired shutter speed or aperture value is displayed.
• Program
shifti~ canceled automatically afterthe picture is taken.
.. Program shift cannot be used with flash.
97