Owner's Manual
Table Of Contents
- Advanced User Guide
- Contents
- Introduction
- Basic Network Settings
- Preparation
- Displaying the Connection Wizard
- Checking the Type of Access Point
- Connecting via WPS (PBC Mode)
- Connecting via WPS (PIN Mode)
- Connecting to a Detected Network Manually
- Connecting to a Network Manually
- Connecting Using an Infrastructure
- Connecting in Camera Access Point Mode
- Setting the IP Address
- Configuring Settings for the Communication Function
- Transferring Images to an FTP Server
- Operating Remotely Using EOS Utility
- Operating the Camera Using Browser Remote
- Linked Shooting
- Synchronizing the Camera Time
- Terminating the Connection and Reconnecting
- Checking and Configuring Network Settings
- Troubleshooting
- Reference
- Trademarks
- Quick Start Guide
- Warranty
Preparing the Receiver Cameras
Configure settings on the camera used as the receiver.
1.
Perform Step 1 through 6 for "Preparing the Sender Camera".
2.
Select [Receiver].
Select [OK] to proceed to the next screen.
3.
Select [OK].
The following screen is displayed.
To use more than one receiver camera, repeat Step 2 and 3 for all the
receiver cameras.
Once setup is complete, no more receiver cameras can be added. You
need to configure the settings again starting from Step 1.
The sender camera's monitor displays the number of receiver cameras
that are detected.
132