Owner's Manual
Table Of Contents
- Advanced User Guide
- Contents
- Introduction
- Basic Network Settings
- Preparation
- Displaying the Connection Wizard
- Checking the Type of Access Point
- Connecting via WPS (PBC Mode)
- Connecting via WPS (PIN Mode)
- Connecting to a Detected Network Manually
- Connecting to a Network Manually
- Connecting Using an Infrastructure
- Connecting in Camera Access Point Mode
- Setting the IP Address
- Configuring Settings for the Communication Function
- Transferring Images to an FTP Server
- Operating Remotely Using EOS Utility
- Operating the Camera Using Browser Remote
- Linked Shooting
- Synchronizing the Camera Time
- Terminating the Connection and Reconnecting
- Checking and Configuring Network Settings
- Troubleshooting
- Reference
- Trademarks
- Quick Start Guide
- Warranty
Connecting the Sender Camera and Receiver Cameras
Configure settings on the sender camera and the receiver camera to establish a connection.
1.
Perform Step 1 through 6 for "Preparing the Sender Camera" and Step
1 through 3 for "Preparing the Receiver Cameras".
2.
Select [OK] on the sender camera.
Check the number of receiver cameras that are connected, and then
select [OK].
Once the cameras are connected, the following screen is displayed.
3.
Select [OK] on all the cameras.
Sender Camera
Receiver Camera
The [Network settings] screen will reappear.
Settings information is stored in the camera. It is not stored in the
transmitter.
133