Owner's Manual
Table Of Contents
- Advanced User Guide
- Contents
- Introduction
- Basic Network Settings
- Preparation
- Displaying the Connection Wizard
- Checking the Type of Access Point
- Connecting via WPS (PBC Mode)
- Connecting via WPS (PIN Mode)
- Connecting to a Detected Network Manually
- Connecting to a Network Manually
- Connecting Using an Infrastructure
- Connecting in Camera Access Point Mode
- Setting the IP Address
- Configuring Settings for the Communication Function
- Transferring Images to an FTP Server
- Operating Remotely Using EOS Utility
- Operating the Camera Using Browser Remote
- Linked Shooting
- Synchronizing the Camera Time
- Terminating the Connection and Reconnecting
- Checking and Configuring Network Settings
- Troubleshooting
- Reference
- Trademarks
- Quick Start Guide
- Warranty
Positioning the Cameras
(A) Sender Camera
(B) Receiver Camera
Set the camera's Live View shooting/Movie shooting switch to < >.
Position the receiver cameras in clear view of the sender camera, without objects
between them.
Receiver cameras can be positioned up to approx. 50 m / 164 ft. from the sender
camera. However, the distance supported for linked shooting may be shorter depending
on the wireless communication conditions, which are affected by how the cameras are
positioned, the usage environment, and weather conditions.
Pressing the shutter button halfway on the sender camera will also put the receiver
cameras in a state corresponding to when their shutter buttons are pressed halfway.
Similarly, fully pressing the shutter button on the sender camera will also put the
receiver cameras in a state corresponding to when their shutter buttons are fully
pressed.
There will be a slight delay in the shutter release timing between the sender and
receiver cameras. (Simultaneous shooting is not possible.)
Caution
Do not use multiple flash units. Although slight, there is a difference in the shutter
release timing, which may cause out-of-sync flash firing and inadequate exposure.
134