Owner's Manual
Table Of Contents
- Advanced User Guide
- Contents
- Introduction
- Basic Network Settings
- Preparation
- Displaying the Connection Wizard
- Checking the Type of Access Point
- Connecting via WPS (PBC Mode)
- Connecting via WPS (PIN Mode)
- Connecting to a Detected Network Manually
- Connecting to a Network Manually
- Connecting Using an Infrastructure
- Connecting in Camera Access Point Mode
- Setting the IP Address
- Configuring Settings for the Communication Function
- Transferring Images to an FTP Server
- Operating Remotely Using EOS Utility
- Operating the Camera Using Browser Remote
- Linked Shooting
- Synchronizing the Camera Time
- Terminating the Connection and Reconnecting
- Checking and Configuring Network Settings
- Troubleshooting
- Reference
- Trademarks
- Quick Start Guide
- Warranty
Connecting the Sender Camera and Receiver Cameras
Checking the Camera's IP Address and SSID
IP Addresses Assigned to a Computer
Connecting the Sender Camera with a Computer
Viewing Images and Shooting Remotely
Connecting the Sender Camera and Receiver Cameras
1.
Prepare the sender camera.
Perform Step 1 through 7 for "Preparing Sender Camera" described in
Basic Linked Shooting.
2.
Select [Manual connect].
Select [OK] to proceed to the next screen.
3.
Specify the channel.
When selecting [Manual setting], specify the same channel on the
sender camera and receiver cameras, as well as on the computer.
Select [OK] to proceed to the next screen.
137