Owner's Manual
Table Of Contents
- Advanced User Guide
- Contents
- Introduction
- Basic Network Settings
- Preparation
- Displaying the Connection Wizard
- Checking the Type of Access Point
- Connecting via WPS (PBC Mode)
- Connecting via WPS (PIN Mode)
- Connecting to a Detected Network Manually
- Connecting to a Network Manually
- Connecting Using an Infrastructure
- Connecting in Camera Access Point Mode
- Setting the IP Address
- Configuring Settings for the Communication Function
- Transferring Images to an FTP Server
- Operating Remotely Using EOS Utility
- Operating the Camera Using Browser Remote
- Linked Shooting
- Synchronizing the Camera Time
- Terminating the Connection and Reconnecting
- Checking and Configuring Network Settings
- Troubleshooting
- Reference
- Trademarks
- Quick Start Guide
- Warranty
Attaching to the Camera
Set the camera's power switch to < > before attaching the transmitter.
The transmitter is powered by the camera. Ensure the camera battery has sufficient
charge. If the battery level drops to 19% or less, you cannot transfer captured images.
1.
Open the terminal cover on the camera.
Pull out the system extension terminal cover and rotate it toward the
front.
2.
Attach the transmitter.
Insert the transmitter terminal and attachment pin in the corresponding
camera system extension terminal and attachment hole.
Push the underside of the transmitter into the camera and turn the
tightening screw in the direction of the arrow.
Turn the tightening screw until it stops rotating to securely attach the
transmitter.
Removing the transmitter
Set the camera's power switch to < >.
Loosen the tightening screw until the transmitter comes off.
14