Owner's Manual
Table Of Contents
- Advanced User Guide
- Contents
- Introduction
- Basic Network Settings
- Preparation
- Displaying the Connection Wizard
- Checking the Type of Access Point
- Connecting via WPS (PBC Mode)
- Connecting via WPS (PIN Mode)
- Connecting to a Detected Network Manually
- Connecting to a Network Manually
- Connecting Using an Infrastructure
- Connecting in Camera Access Point Mode
- Setting the IP Address
- Configuring Settings for the Communication Function
- Transferring Images to an FTP Server
- Operating Remotely Using EOS Utility
- Operating the Camera Using Browser Remote
- Linked Shooting
- Synchronizing the Camera Time
- Terminating the Connection and Reconnecting
- Checking and Configuring Network Settings
- Troubleshooting
- Reference
- Trademarks
- Quick Start Guide
- Warranty
Synchronizing the Time Between the Sender Camera and the
Receiver Cameras
Use the menu on the sender camera and the receiver cameras to synchronize the time
between them.
1.
Perform Step 1 through 6 for "Preparing the Sender Camera" and Step
1 through 3 for "Preparing the Receiver Cameras".
2.
Select [OK] on the sender camera.
Check the number of receiver cameras that are connected, and then
select [OK].
The next screen is displayed once the time is synchronized.
3.
Select [OK] on all the cameras.
149