Owner's Manual
Table Of Contents
- Advanced User Guide
- Contents
- Introduction
- Basic Network Settings
- Preparation
- Displaying the Connection Wizard
- Checking the Type of Access Point
- Connecting via WPS (PBC Mode)
- Connecting via WPS (PIN Mode)
- Connecting to a Detected Network Manually
- Connecting to a Network Manually
- Connecting Using an Infrastructure
- Connecting in Camera Access Point Mode
- Setting the IP Address
- Configuring Settings for the Communication Function
- Transferring Images to an FTP Server
- Operating Remotely Using EOS Utility
- Operating the Camera Using Browser Remote
- Linked Shooting
- Synchronizing the Camera Time
- Terminating the Connection and Reconnecting
- Checking and Configuring Network Settings
- Troubleshooting
- Reference
- Trademarks
- Quick Start Guide
- Warranty
NW* / Comm settings*
• Select this option to change, add or cancel the comm settings.
• By selecting [Select from list], a list of comm settings saved in the camera will
appear. Select a comm settings option you will use.
• By selecting [Clear selected], the comm settings registered in the connection
settings are canceled. On the confirmation dialog, select [OK].
MODE* / Function settings*
• Select this option to change, add or cancel the function settings.
• By selecting [Select from list], a list of function settings saved in the camera will
appear. Select a function settings option you will use.
• By selecting [Clear selected], the function settings registered in the connection
settings are canceled. On the confirmation dialog, select [OK].
Note
Two types of comm settings and two types of function settings can be registered to
a single set of connection settings.
Canceling all the function settings removes the comm settings, and the connection
settings become [Unspecified].
159