Owner's Manual
Table Of Contents
- Advanced User Guide
- Contents
- Introduction
- Basic Network Settings
- Preparation
- Displaying the Connection Wizard
- Checking the Type of Access Point
- Connecting via WPS (PBC Mode)
- Connecting via WPS (PIN Mode)
- Connecting to a Detected Network Manually
- Connecting to a Network Manually
- Connecting Using an Infrastructure
- Connecting in Camera Access Point Mode
- Setting the IP Address
- Configuring Settings for the Communication Function
- Transferring Images to an FTP Server
- Operating Remotely Using EOS Utility
- Operating the Camera Using Browser Remote
- Linked Shooting
- Synchronizing the Camera Time
- Terminating the Connection and Reconnecting
- Checking and Configuring Network Settings
- Troubleshooting
- Reference
- Trademarks
- Quick Start Guide
- Warranty
What to check on the DHCP server
Is the power of the DHCP server turned on?
• Turn on the DHCP server.
Are there enough addresses for assignment by the DHCP server?
• Increase the number of addresses that can be assigned by the DHCP server.
• Remove devices whose IP addresses are assigned by the DHCP server from the
network to reduce the number of addresses in use.
Is the DHCP server working correctly?
• Check the DHCP server settings to make sure it is working correctly as a DHCP
server.
• If applicable, ask your network administrator to ensure that the DHCP server is
working.
What to check on the network as a whole
Does your network include a router or similar device that serves as a gateway?
• If applicable, obtain the network gateway address from your network administrator
and enter it on the transmitter ( , ).
• Make sure that the gateway address setting is correctly entered on all network
devices, including the transmitter.
Note
Responding to Error Messages 21 – 23
If Error Messages 21 to 23 appear, verify the following as well.
Are the transmitter and the access point set to use the same password for
authentication?
• This error occurs if you enter a wrong password when the authentication
method for encryption is set to [Open system]. Make sure to set a correct
password for the transmitter by verifying the uppercase and lowercase letters
used in it ( ).
179