Owner's Manual
Table Of Contents
- Advanced User Guide
- Contents
- Introduction
- Basic Network Settings
- Preparation
- Displaying the Connection Wizard
- Checking the Type of Access Point
- Connecting via WPS (PBC Mode)
- Connecting via WPS (PIN Mode)
- Connecting to a Detected Network Manually
- Connecting to a Network Manually
- Connecting Using an Infrastructure
- Connecting in Camera Access Point Mode
- Setting the IP Address
- Configuring Settings for the Communication Function
- Transferring Images to an FTP Server
- Operating Remotely Using EOS Utility
- Operating the Camera Using Browser Remote
- Linked Shooting
- Synchronizing the Camera Time
- Terminating the Connection and Reconnecting
- Checking and Configuring Network Settings
- Troubleshooting
- Reference
- Trademarks
- Quick Start Guide
- Warranty
23: Device with same IP address exists on selected network
Is another device on the transmitter network using the same IP address as the
transmitter?
• Change the transmitter's IP address to avoid using the same address as another
device on the network. Otherwise, change the IP address of the device that has a
duplicated address.
• If the transmitter's IP address is set to [Manual setting] in network environments
using a DHCP server, change the setting to [Auto setting] ( ).
41: Cannot connect to FTP server
What to check on the transmitter
The transmitter's proxy server is set to [Enable]. Is this the correct setting?
• If no proxy server is used, set the transmitter's proxy server to [Disable] ( ).
Do the transmitter's [Address setting] and [Port number setting] match those of
the proxy server?
• Configure the transmitter's proxy server address and port number settings to match
those of the proxy server ( ).
Are the transmitter's proxy server settings correctly entered on the DNS server?
• Make sure that the proxy server's [Address] is correctly entered on the DNS server.
Did you set the correct IP address of the FTP server for the transmitter?
• Configure the IP address on the transmitter to match the actual FTP server address
( ).
Are the transmitter and the access point set to use the same encryption key for
authentication?
• This error occurs if the encryption keys do not match when the authentication
method for encryption is set to [Open system].
The encryption key is case-sensitive. Make sure to enter the correct encryption key
for authentication on the transmitter by verifying the uppercase and lowercase
letters used in it ( ).
181