Owner's Manual
Table Of Contents
- Advanced User Guide
- Contents
- Introduction
- Basic Network Settings
- Preparation
- Displaying the Connection Wizard
- Checking the Type of Access Point
- Connecting via WPS (PBC Mode)
- Connecting via WPS (PIN Mode)
- Connecting to a Detected Network Manually
- Connecting to a Network Manually
- Connecting Using an Infrastructure
- Connecting in Camera Access Point Mode
- Setting the IP Address
- Configuring Settings for the Communication Function
- Transferring Images to an FTP Server
- Operating Remotely Using EOS Utility
- Operating the Camera Using Browser Remote
- Linked Shooting
- Synchronizing the Camera Time
- Terminating the Connection and Reconnecting
- Checking and Configuring Network Settings
- Troubleshooting
- Reference
- Trademarks
- Quick Start Guide
- Warranty
On the transmitter, does [Port number setting] for the FTP server match the actual
port number of the FTP server?
• Configure the same port number (usually 21 for FTP/FTPS and 22 for SFTP) on the
transmitter and the FTP server. Configure the FTP server's port number on the
transmitter ( ).
Are the transmitter's FTP server settings correctly entered on the DNS server?
• Make sure that [Server name] of the configured FTP server is correctly entered on
the DNS server. In addition, make sure that [Server name] of the FTP server you
will use is correctly entered on the transmitter ( ).
What to check on the FTP server
Is the FTP server working correctly?
• Configure the computer correctly to function as an FTP server.
• If applicable, obtain the FTP server's address setting and port number from your
network administrator and enter them on the transmitter.
Is the power of the FTP server turned on?
• Turn on the FTP server. The server may have been turned off because it is in
energy-saving mode.
Does the IP address configured on the FTP server match the [Address] setting for
the FTP server on the transmitter?
• Configure the IP address on the transmitter to match the actual FTP server address
( ).
Is the FTP server configured to allow access from certain IP addresses only?
• Check the transmitter's IP address in [Confirm settings] ( ) and change the
settings on the FTP server.
Is a firewall or other security software enabled?
• Some security software uses a firewall to restrict access to the FTP server. Change
the firewall settings to allow access to the FTP server.
• If you set [Passive mode] to [Enable] on the transmitter, you may be able to
establish a connection with the FTP server ( ).
Are you connecting to the FTP server via a broadband router?
• Some broadband routers use a firewall to restrict access to the FTP server. Change
the firewall settings to allow access to the FTP server.
• If you set [Passive mode] to [Enable] on the transmitter, you may be able to
establish a connection with the FTP server ( ).
182