Owner's Manual
Table Of Contents
- Advanced User Guide
- Contents
- Introduction
- Basic Network Settings
- Preparation
- Displaying the Connection Wizard
- Checking the Type of Access Point
- Connecting via WPS (PBC Mode)
- Connecting via WPS (PIN Mode)
- Connecting to a Detected Network Manually
- Connecting to a Network Manually
- Connecting Using an Infrastructure
- Connecting in Camera Access Point Mode
- Setting the IP Address
- Configuring Settings for the Communication Function
- Transferring Images to an FTP Server
- Operating Remotely Using EOS Utility
- Operating the Camera Using Browser Remote
- Linked Shooting
- Synchronizing the Camera Time
- Terminating the Connection and Reconnecting
- Checking and Configuring Network Settings
- Troubleshooting
- Reference
- Trademarks
- Quick Start Guide
- Warranty
67: Incorrect wireless LAN encryption method
Are the transmitter and the access point set to use the same encryption method?
• The transmitter supports WEP, TKIP, and AES encryption ( ).
If filtering by MAC address is active, is the MAC address of the transmitter in use
registered at the access point?
• Register the MAC address of the transmitter in use at the access point. The MAC
address can be found on the [MAC address] screen ( ).
68: Cannot connect to wireless LAN terminal. Retry from the
beginning.
Did you hold down the WPS (Wi-Fi Protected Setup) button on the access point
for the specified period of time?
• Hold down the WPS button for the period of time specified in the instruction manual
of the access point.
Are you trying to establish a connection near the access point?
• Try establishing the connection when both devices are within reach of each other.
69: Multiple wireless LAN terminals have been found. Cannot
connect. Retry from the beginning.
Another access point is using the PBC (Pushbutton connection mode) of WPS
(Wi-Fi Protected Setup) to establish a connection.
• Try connecting after a while or use PIN mode (PIN code connection mode) for the
connection ( ).
71: Cannot connect to receiver camera
Are you following the correct procedure to establish a connection with the
receiver camera?
• Make sure to follow the correct procedure for controlling the receiver cameras
( , ).
Are the receiver cameras placed too far from the sender camera?
• Place the receiver cameras closer to the sender camera.
Are there many devices in your surroundings that emit radio waves?
• Move away from that area and try controlling the receiver cameras again ( , ).
188