Owner's Manual
Table Of Contents
- Advanced User Guide
- Contents
- Introduction
- Basic Network Settings
- Preparation
- Displaying the Connection Wizard
- Checking the Type of Access Point
- Connecting via WPS (PBC Mode)
- Connecting via WPS (PIN Mode)
- Connecting to a Detected Network Manually
- Connecting to a Network Manually
- Connecting Using an Infrastructure
- Connecting in Camera Access Point Mode
- Setting the IP Address
- Configuring Settings for the Communication Function
- Transferring Images to an FTP Server
- Operating Remotely Using EOS Utility
- Operating the Camera Using Browser Remote
- Linked Shooting
- Synchronizing the Camera Time
- Terminating the Connection and Reconnecting
- Checking and Configuring Network Settings
- Troubleshooting
- Reference
- Trademarks
- Quick Start Guide
- Warranty
72: Cannot connect to sender camera
Are you following the correct procedure to establish a connection with the sender
camera?
• Make sure to follow the correct procedure for controlling the sender camera
( , ).
Is the sender camera placed too far from the receiver cameras?
• Place the sender camera closer to the receiver cameras.
Are there many devices in your surroundings that emit radio waves?
• Move away from that area and try controlling the sender camera again ( , ).
73: Could not synchronize the time
Are you following the correct procedure to establish a connection between the
sender camera and receiver cameras?
• Make sure to follow the correct procedure for controlling the sender and receiver
cameras ( ).
Is the sender camera placed too far from the receiver cameras?
• Place the sender camera closer to the receiver cameras.
Are there many devices in your surroundings that emit radio waves?
• Move away from that area and try syncing the time again ( ).
82: Wireless File Transmitter not connected
Is the transmitter attached correctly?
• Make sure that the transmitter is attached to the camera correctly ( ).
83: Wireless LAN connection terminated because of high WFT
temperature
Because the transmitter's temperature has increased, wireless communication
was temporarily suspended and connection with the wireless LAN was cut off.
• Allow the transmitter to cool down by shielding it from direct sunlight. Once the
transmitter cools down, the transmitter automatically attempts to reconnect.
91: Other error
A problem other than Error 11 to 83 occurred.
• Turn off and on the camera's power switch.
189