Owner's Manual
Table Of Contents
- Advanced User Guide
- Contents
- Introduction
- Basic Network Settings
- Preparation
- Displaying the Connection Wizard
- Checking the Type of Access Point
- Connecting via WPS (PBC Mode)
- Connecting via WPS (PIN Mode)
- Connecting to a Detected Network Manually
- Connecting to a Network Manually
- Connecting Using an Infrastructure
- Connecting in Camera Access Point Mode
- Setting the IP Address
- Configuring Settings for the Communication Function
- Transferring Images to an FTP Server
- Operating Remotely Using EOS Utility
- Operating the Camera Using Browser Remote
- Linked Shooting
- Synchronizing the Camera Time
- Terminating the Connection and Reconnecting
- Checking and Configuring Network Settings
- Troubleshooting
- Reference
- Trademarks
- Quick Start Guide
- Warranty
Displaying the Connection Wizard
This section describes how to add connection settings by following the connection wizard.
If an error is displayed, see Troubleshooting and check the settings.
Pressing the shutter button or other camera controls during configuration using the
connection wizard will close the connection wizard. Do not press the shutter button or
other controls until configuration is finished.
[ : Network settings] is only available when [ : Multiple exposure] is set to
[Disable].
1.
Press the < > button on the camera.
2.
Select [ : Network settings].
3.
Select [Enable].
4.
Select [Connection settings].
19