Owner's Manual
Table Of Contents
- Advanced User Guide
- Contents
- Introduction
- Basic Network Settings
- Preparation
- Displaying the Connection Wizard
- Checking the Type of Access Point
- Connecting via WPS (PBC Mode)
- Connecting via WPS (PIN Mode)
- Connecting to a Detected Network Manually
- Connecting to a Network Manually
- Connecting Using an Infrastructure
- Connecting in Camera Access Point Mode
- Setting the IP Address
- Configuring Settings for the Communication Function
- Transferring Images to an FTP Server
- Operating Remotely Using EOS Utility
- Operating the Camera Using Browser Remote
- Linked Shooting
- Synchronizing the Camera Time
- Terminating the Connection and Reconnecting
- Checking and Configuring Network Settings
- Troubleshooting
- Reference
- Trademarks
- Quick Start Guide
- Warranty
Notes for Using Multiple Wireless Transmitters
When multiple cameras with a wireless transmitter attached are connected to one
access point, make sure that the cameras' IP addresses are different.
When multiple cameras with a wireless transmitter attached are connected to one
access point, the transmission rate drops.
When there are multiple IEEE 802.11n/g/b (2.4 GHz band) access points, leave a gap of
four channels between each wireless LAN channel to reduce radio wave interference.
For example, use channels 1, 6, and 11, channels 2, 7, and 12, or channels 3, 8, and
13.
When IEEE 802.11ac/n/a can be used (on the 5 GHz band), switch to IEEE
802.11ac/n/a (on the 5 GHz band) and specify a different channel.
192