Owner's Manual
Table Of Contents
- Advanced User Guide
- Contents
- Introduction
- Basic Network Settings
- Preparation
- Displaying the Connection Wizard
- Checking the Type of Access Point
- Connecting via WPS (PBC Mode)
- Connecting via WPS (PIN Mode)
- Connecting to a Detected Network Manually
- Connecting to a Network Manually
- Connecting Using an Infrastructure
- Connecting in Camera Access Point Mode
- Setting the IP Address
- Configuring Settings for the Communication Function
- Transferring Images to an FTP Server
- Operating Remotely Using EOS Utility
- Operating the Camera Using Browser Remote
- Linked Shooting
- Synchronizing the Camera Time
- Terminating the Connection and Reconnecting
- Checking and Configuring Network Settings
- Troubleshooting
- Reference
- Trademarks
- Quick Start Guide
- Warranty
5.
Select [SET*].
6.
Select [Create with wizard].
If the camera has multiple registered communication settings and
function settings, you can add connection settings by selecting [Create
from list] and combining registered settings.
You can also add connection settings by using connection settings
stored on the card. Configure the settings by selecting [Load settings
from card] ( ).
7.
Select the setting method.
Select an item and select [OK] to go to the next screen.
Select [Configure online] to configure the connection settings and
network settings at the same time.
Select [Configure offline] to configure only the connection settings for
[FTP trans.] and [Browser Remote].
20