Owner's Manual
Table Of Contents
- Advanced User Guide
- Contents
- Introduction
- Basic Network Settings
- Preparation
- Displaying the Connection Wizard
- Checking the Type of Access Point
- Connecting via WPS (PBC Mode)
- Connecting via WPS (PIN Mode)
- Connecting to a Detected Network Manually
- Connecting to a Network Manually
- Connecting Using an Infrastructure
- Connecting in Camera Access Point Mode
- Setting the IP Address
- Configuring Settings for the Communication Function
- Transferring Images to an FTP Server
- Operating Remotely Using EOS Utility
- Operating the Camera Using Browser Remote
- Linked Shooting
- Synchronizing the Camera Time
- Terminating the Connection and Reconnecting
- Checking and Configuring Network Settings
- Troubleshooting
- Reference
- Trademarks
- Quick Start Guide
- Warranty
Use TCP/IPv6
• Set IPv6 to [Enable] or [Disable].
Manual setting
• To set the IP addresses manually, select [Enable]. [DNS server] will be set to
[Manual setting] and you will be able to specify [DNS address], [Manual address],
[Prefix length], and [Gateway].
DNS server
• To set the IP address of the DNS server manually, select [Manual setting].
• If you do not use a DNS server, select [Disable].
• When [Auto assign] is configured, if you set [Manual setting] to [Enable], [Manual
setting] will be configured.
201