Owner's Manual
Table Of Contents
- Advanced User Guide
- Contents
- Introduction
- Basic Network Settings
- Preparation
- Displaying the Connection Wizard
- Checking the Type of Access Point
- Connecting via WPS (PBC Mode)
- Connecting via WPS (PIN Mode)
- Connecting to a Detected Network Manually
- Connecting to a Network Manually
- Connecting Using an Infrastructure
- Connecting in Camera Access Point Mode
- Setting the IP Address
- Configuring Settings for the Communication Function
- Transferring Images to an FTP Server
- Operating Remotely Using EOS Utility
- Operating the Camera Using Browser Remote
- Linked Shooting
- Synchronizing the Camera Time
- Terminating the Connection and Reconnecting
- Checking and Configuring Network Settings
- Troubleshooting
- Reference
- Trademarks
- Quick Start Guide
- Warranty
Connecting via WPS (PBC Mode)
These instructions are continued from Checking the Type of Access Point.
This is a connection mode available when using an access point compatible with WPS. In
pushbutton connection mode (PBC mode), the camera and the access point can be
connected simply by pressing the WPS button on the access point.
If multiple access points are active in the surrounding area, it may be more difficult to
establish a connection. In such a case, try using [WPS (PIN mode)] to establish a
connection.
Check the position of the WPS button on the access point in advance.
It may take approx. one minute to establish a connection.
1.
Select [Connect with WPS].
2.
Select [WPS (PBC mode)].
Select [OK] to proceed to the next screen.
25