Owner's Manual
Table Of Contents
- Advanced User Guide
- Contents
- Introduction
- Basic Network Settings
- Preparation
- Displaying the Connection Wizard
- Checking the Type of Access Point
- Connecting via WPS (PBC Mode)
- Connecting via WPS (PIN Mode)
- Connecting to a Detected Network Manually
- Connecting to a Network Manually
- Connecting Using an Infrastructure
- Connecting in Camera Access Point Mode
- Setting the IP Address
- Configuring Settings for the Communication Function
- Transferring Images to an FTP Server
- Operating Remotely Using EOS Utility
- Operating the Camera Using Browser Remote
- Linked Shooting
- Synchronizing the Camera Time
- Terminating the Connection and Reconnecting
- Checking and Configuring Network Settings
- Troubleshooting
- Reference
- Trademarks
- Quick Start Guide
- Warranty
Connecting via WPS (PIN Mode)
These instructions are continued from Checking the Type of Access Point.
This is a connection mode available when using an access point compatible with WPS. In
PIN code connection mode (PIN mode), an 8-digit identification number specified on the
camera is set at the access point to establish a connection.
Even if there are multiple access points active in the surrounding area, a relatively
reliable connection can be established using this shared identification number.
It may take approx. one minute to establish a connection.
1.
Select [Connect with WPS].
2.
Select [WPS (PIN mode)].
Select [OK] to proceed to the next screen.
27