Owner's Manual
Table Of Contents
- Advanced User Guide
- Contents
- Introduction
- Basic Network Settings
- Preparation
- Displaying the Connection Wizard
- Checking the Type of Access Point
- Connecting via WPS (PBC Mode)
- Connecting via WPS (PIN Mode)
- Connecting to a Detected Network Manually
- Connecting to a Network Manually
- Connecting Using an Infrastructure
- Connecting in Camera Access Point Mode
- Setting the IP Address
- Configuring Settings for the Communication Function
- Transferring Images to an FTP Server
- Operating Remotely Using EOS Utility
- Operating the Camera Using Browser Remote
- Linked Shooting
- Synchronizing the Camera Time
- Terminating the Connection and Reconnecting
- Checking and Configuring Network Settings
- Troubleshooting
- Reference
- Trademarks
- Quick Start Guide
- Warranty
3.
Specify the PIN code.
At the access point, specify the 8-digit PIN code displayed on the
camera's monitor.
For instructions on setting PIN codes at the access point, refer to the
access point's instruction manual.
After the PIN code is specified, select [OK].
4.
Connect to the access point.
Select [OK] to establish a connection with the access point.
When a connection with the access point is established, the next
screen is displayed.
Go to Setting the IP Address.
28