Owner's Manual
Table Of Contents
- Advanced User Guide
- Contents
- Introduction
- Basic Network Settings
- Preparation
- Displaying the Connection Wizard
- Checking the Type of Access Point
- Connecting via WPS (PBC Mode)
- Connecting via WPS (PIN Mode)
- Connecting to a Detected Network Manually
- Connecting to a Network Manually
- Connecting Using an Infrastructure
- Connecting in Camera Access Point Mode
- Setting the IP Address
- Configuring Settings for the Communication Function
- Transferring Images to an FTP Server
- Operating Remotely Using EOS Utility
- Operating the Camera Using Browser Remote
- Linked Shooting
- Synchronizing the Camera Time
- Terminating the Connection and Reconnecting
- Checking and Configuring Network Settings
- Troubleshooting
- Reference
- Trademarks
- Quick Start Guide
- Warranty
Specifying the Authentication for the Access Point
3.
Select the authentication.
Select an item and select [OK] to go to the next screen.
If you select [Open system], the [Encryption settings] screen will be
displayed. Select [None] or [WEP] on this screen.
Entering the Access Point Encryption Key
Enter the encryption key (password) specified for the access point. For details on the
specified encryption key, refer to the access point's instruction manual.
The screens displayed in steps 4 and 5 below vary depending on the authentication and
encryption specified for the access point.
Go to Setting the IP Address when the [IP address set.] screen is displayed instead of
the screens for steps 4 and 5.
4.
Select a key index.
The [Key index] screen is displayed when [Shared key] and [WEP]
are selected in step 3.
Select the key index number specified for the access point.
Select [OK] to proceed to the next screen.
32