Owner's Manual
Table Of Contents
- Advanced User Guide
- Contents
- Introduction
- Basic Network Settings
- Preparation
- Displaying the Connection Wizard
- Checking the Type of Access Point
- Connecting via WPS (PBC Mode)
- Connecting via WPS (PIN Mode)
- Connecting to a Detected Network Manually
- Connecting to a Network Manually
- Connecting Using an Infrastructure
- Connecting in Camera Access Point Mode
- Setting the IP Address
- Configuring Settings for the Communication Function
- Transferring Images to an FTP Server
- Operating Remotely Using EOS Utility
- Operating the Camera Using Browser Remote
- Linked Shooting
- Synchronizing the Camera Time
- Terminating the Connection and Reconnecting
- Checking and Configuring Network Settings
- Troubleshooting
- Reference
- Trademarks
- Quick Start Guide
- Warranty
Connecting in Camera Access Point Mode
These instructions are continued from Displaying the Connection Wizard.
Camera access point mode is a connection mode for connecting the camera directly to each
device via a wireless connection without using an access point. The following two
connection methods are available.
Connecting with Easy Connection
Connecting with a Manual Connection
Connecting with Easy Connection
The network settings for the camera access point mode are configured automatically.
To establish a connection, operations on the computer or smartphone, etc., are
required. For details, refer to the corresponding device's instruction manual.
1.
Select [Camera access point mode].
For [Configure online]
For [Configure offline]
On the [Conn. method] screen, select [OK] to go to the next screen.
37