Owner's Manual
Table Of Contents
- Advanced User Guide
- Contents
- Introduction
- Basic Network Settings
- Preparation
- Displaying the Connection Wizard
- Checking the Type of Access Point
- Connecting via WPS (PBC Mode)
- Connecting via WPS (PIN Mode)
- Connecting to a Detected Network Manually
- Connecting to a Network Manually
- Connecting Using an Infrastructure
- Connecting in Camera Access Point Mode
- Setting the IP Address
- Configuring Settings for the Communication Function
- Transferring Images to an FTP Server
- Operating Remotely Using EOS Utility
- Operating the Camera Using Browser Remote
- Linked Shooting
- Synchronizing the Camera Time
- Terminating the Connection and Reconnecting
- Checking and Configuring Network Settings
- Troubleshooting
- Reference
- Trademarks
- Quick Start Guide
- Warranty
4.
Select the desired encryption setting.
For encryption, select [AES].
Select [OK] to display the next screen.
When [AES] is selected, the [Password] screen is displayed. Press
< > to display the virtual keyboard ( ), then enter the encryption
key. After entering the SSID, press the < > button.
5.
Select the IP address setting.
To set the IP address automatically, perform step 1 in Setting the IP
Address Automatically.
To set the IP address manually, perform steps 1 to 4 in Setting the IP
Address Manually.
When the settings are complete, the next screen is displayed.
6.
Select [OK].
The next screen is displayed.
43