Owner's Manual
Table Of Contents
- Advanced User Guide
- Contents
- Introduction
- Basic Network Settings
- Preparation
- Displaying the Connection Wizard
- Checking the Type of Access Point
- Connecting via WPS (PBC Mode)
- Connecting via WPS (PIN Mode)
- Connecting to a Detected Network Manually
- Connecting to a Network Manually
- Connecting Using an Infrastructure
- Connecting in Camera Access Point Mode
- Setting the IP Address
- Configuring Settings for the Communication Function
- Transferring Images to an FTP Server
- Operating Remotely Using EOS Utility
- Operating the Camera Using Browser Remote
- Linked Shooting
- Synchronizing the Camera Time
- Terminating the Connection and Reconnecting
- Checking and Configuring Network Settings
- Troubleshooting
- Reference
- Trademarks
- Quick Start Guide
- Warranty
Setting the IP Address
These instructions are continued from configuring the connection settings for using an
access point.
Select the IP address setting method and set the IP address to the camera. When using
IPv6, a connection can only be established using IPv6. A connection cannot be established
using IPv4.
Setting the IP Address Automatically
Setting the IP Address Manually
Setting the IP Address Automatically
The IP address settings are configured automatically.
1.
Select [Auto setting].
Select [OK] to proceed to the next screen.
If [Auto setting] results in an error, configure the IP address manually
( ).
2.
Select the IPv6 setting.
Select an item and select [OK] to go to the next screen.
If you select [Enable], configure the IPv6 settings after completing all
other settings ( ).
When the settings are complete, the next screen is displayed.
47