Owner's Manual
Table Of Contents
- Advanced User Guide
- Contents
- Introduction
- Basic Network Settings
- Preparation
- Displaying the Connection Wizard
- Checking the Type of Access Point
- Connecting via WPS (PBC Mode)
- Connecting via WPS (PIN Mode)
- Connecting to a Detected Network Manually
- Connecting to a Network Manually
- Connecting Using an Infrastructure
- Connecting in Camera Access Point Mode
- Setting the IP Address
- Configuring Settings for the Communication Function
- Transferring Images to an FTP Server
- Operating Remotely Using EOS Utility
- Operating the Camera Using Browser Remote
- Linked Shooting
- Synchronizing the Camera Time
- Terminating the Connection and Reconnecting
- Checking and Configuring Network Settings
- Troubleshooting
- Reference
- Trademarks
- Quick Start Guide
- Warranty
3.
Enter the desired values.
Use < > to select the input position in the upper area and use
< > to select a number. Press < > to enter the selected number.
To set the entered values and return to the screen in step 2, press the
< > button.
4.
Select [OK].
When you have completed setting the necessary items, select [OK].
The next screen is displayed.
If you are not sure what to enter, see Checking Network Settings or ask
the network administrator or similar person.
5.
Select the IPv6 setting.
Select an item and select [OK] to go to the next screen.
If you select [Enable], configure the IPv6 settings after completing all
other settings ( ).
When the settings are complete, the next screen is displayed.
50