Owner's Manual
Table Of Contents
- Advanced User Guide
- Contents
- Introduction
- Basic Network Settings
- Preparation
- Displaying the Connection Wizard
- Checking the Type of Access Point
- Connecting via WPS (PBC Mode)
- Connecting via WPS (PIN Mode)
- Connecting to a Detected Network Manually
- Connecting to a Network Manually
- Connecting Using an Infrastructure
- Connecting in Camera Access Point Mode
- Setting the IP Address
- Configuring Settings for the Communication Function
- Transferring Images to an FTP Server
- Operating Remotely Using EOS Utility
- Operating the Camera Using Browser Remote
- Linked Shooting
- Synchronizing the Camera Time
- Terminating the Connection and Reconnecting
- Checking and Configuring Network Settings
- Troubleshooting
- Reference
- Trademarks
- Quick Start Guide
- Warranty
5.
Configure the SSH login authentication settings.
Select [User name] and [Password] and enter the user name and
password for SSH password authentication with the displayed virtual
keyboard ( ).
Select [OK] to proceed to the next screen.
6.
Set the passive mode.
This is not displayed if you selected [SFTP] in step 1.
Select [OK] to proceed to the next screen.
If "Error 41: Cannot connect to FTP server" is displayed in step 9,
setting [Passive mode] to [Enable] may resolve the error.
7.
Set the proxy server.
This is not displayed if you selected [FTPS] or [SFTP] in step 1.
Select [OK] to proceed to the next screen.
57