Owner's Manual
Table Of Contents
- Advanced User Guide
- Contents
- Introduction
- Basic Network Settings
- Preparation
- Displaying the Connection Wizard
- Checking the Type of Access Point
- Connecting via WPS (PBC Mode)
- Connecting via WPS (PIN Mode)
- Connecting to a Detected Network Manually
- Connecting to a Network Manually
- Connecting Using an Infrastructure
- Connecting in Camera Access Point Mode
- Setting the IP Address
- Configuring Settings for the Communication Function
- Transferring Images to an FTP Server
- Operating Remotely Using EOS Utility
- Operating the Camera Using Browser Remote
- Linked Shooting
- Synchronizing the Camera Time
- Terminating the Connection and Reconnecting
- Checking and Configuring Network Settings
- Troubleshooting
- Reference
- Trademarks
- Quick Start Guide
- Warranty
4.
Select the type of images to transfer.
RAW+JPEG transfer
• Select [RAW+JPEG transfer], then select [JPEG only], [RAW
only], or [RAW+JPEG].
RAW+HEIF transfer
• Select [RAW+HEIF transfer], then select [HEIF only], [RAW only],
or [RAW+HEIF].
Note
If images are specified to be recorded as RAW on one CFexpress card and JPEG
or HEIF on another card, determine the image to be transferred by using the [RAW
+JPEG transfer] or [RAW+HEIF transfer] setting. Also use this setting when RAW
+JPEG or RAW+HEIF images are simultaneously recorded on a single card.
The captured images are also stored on the card.
If images of the same size are simultaneously recorded on two cards, the images
recorded on the card that is preferentially specified in [ Record/play] or [
Play] under [ : Record func+card/folder sel.] will be transferred.
68