Owner's Manual
Table Of Contents
- Advanced User Guide
- Contents
- Introduction
- Basic Network Settings
- Preparation
- Displaying the Connection Wizard
- Checking the Type of Access Point
- Connecting via WPS (PBC Mode)
- Connecting via WPS (PIN Mode)
- Connecting to a Detected Network Manually
- Connecting to a Network Manually
- Connecting Using an Infrastructure
- Connecting in Camera Access Point Mode
- Setting the IP Address
- Configuring Settings for the Communication Function
- Transferring Images to an FTP Server
- Operating Remotely Using EOS Utility
- Operating the Camera Using Browser Remote
- Linked Shooting
- Synchronizing the Camera Time
- Terminating the Connection and Reconnecting
- Checking and Configuring Network Settings
- Troubleshooting
- Reference
- Trademarks
- Quick Start Guide
- Warranty
In a card
Select [All images].
Select the method of selection you want to use.
• When [Select transfer failed images] is selected, images stored on the card whose
transfer has failed are selected.
• When [Select images not transferred] is selected, images stored on the card that
have not yet been transferred are selected.
• When [Sel transfer fail img ( only)] is selected, protected images stored on the
card whose transfer has failed are selected.
• When [Sel img not transfer. ( only)] is selected, protected images recorded on
the card that have not yet been transferred are selected.
• When [Clear transfer history] is selected, the transfer history of images stored on
the card is cleared.
• When [Select images not transferred] is selected after the transfer history has
been cleared, all the images stored on the card are transferred again.
• When [Sel img not transfer. ( only)] is selected after the transfer history has
been cleared, all the protected images stored on the card are transferred again.
When [OK] is selected, the selected image is transferred to the FTP server.
75