Owner's Manual
Table Of Contents
- Advanced User Guide
- Contents
- Introduction
- Basic Network Settings
- Preparation
- Displaying the Connection Wizard
- Checking the Type of Access Point
- Connecting via WPS (PBC Mode)
- Connecting via WPS (PIN Mode)
- Connecting to a Detected Network Manually
- Connecting to a Network Manually
- Connecting Using an Infrastructure
- Connecting in Camera Access Point Mode
- Setting the IP Address
- Configuring Settings for the Communication Function
- Transferring Images to an FTP Server
- Operating Remotely Using EOS Utility
- Operating the Camera Using Browser Remote
- Linked Shooting
- Synchronizing the Camera Time
- Terminating the Connection and Reconnecting
- Checking and Configuring Network Settings
- Troubleshooting
- Reference
- Trademarks
- Quick Start Guide
- Warranty
Auto Retry if Transfer Fails
If transfer fails, the < > lamp on the camera blinks in red. In this case, press the
< > button and select [ : Network settings]. The following screen is displayed.
To resolve the error displayed, see the Responding to Error Messages.
Once the cause of the error is eliminated, the images whose transfer previously failed will be
re-transferred automatically. With this option activated, transfer is attempted again
automatically after failure, whether automatic transfer is used or captured images are
transferred via FTP. Note that when you cancel image transfer or turn off the transmitter or
camera, the image will not be re-transferred automatically.
See Batch Transfer and transfer the images.
Note
If you prefer not to disconnect from the LAN, set [Power saving] on the [FTP
transfer settings] screen ( ) to [Disable].
82