Owner's Manual
Table Of Contents
- Advanced User Guide
- Contents
- Introduction
- Basic Network Settings
- Preparation
- Displaying the Connection Wizard
- Checking the Type of Access Point
- Connecting via WPS (PBC Mode)
- Connecting via WPS (PIN Mode)
- Connecting to a Detected Network Manually
- Connecting to a Network Manually
- Connecting Using an Infrastructure
- Connecting in Camera Access Point Mode
- Setting the IP Address
- Configuring Settings for the Communication Function
- Transferring Images to an FTP Server
- Operating Remotely Using EOS Utility
- Operating the Camera Using Browser Remote
- Linked Shooting
- Synchronizing the Camera Time
- Terminating the Connection and Reconnecting
- Checking and Configuring Network Settings
- Troubleshooting
- Reference
- Trademarks
- Quick Start Guide
- Warranty
Operations on the camera - 2
5.
Select [OK].
When the camera detects the computer on which you clicked
[Connect] in step 4, the above screen is displayed.
Select [OK] to proceed to the next screen.
6.
Select [OK].
7.
Select [OK].
The [Network settings] screen will reappear.
The < > lamp on the camera will light in green.
Settings information is stored in the camera. It is not stored in the
transmitter.
The settings for connecting to EOS Utility are now complete.
There is no need to complete pairing again if you continue using the camera to which
the transmitter is attached and the computer together after pairing without changing the
settings.
87