User's Manual

• If you use a paper core narrower than the paper to be wound, adjust the position of the
holder stopper, so that there is a gap between the holder stopper and the paper.
5. Make sure the leading edge of the roll paper is not lifting up from the paper core, and if there
are places lifting up, tape in additional places so that the paper does not lift up.
6.
Push roll holder downward and check that roll holder is not lifting up.
◦ Outward Winding
◦
Inward Winding
Important
• If the roll holder lifts up, it may cause an error.
7. Make sure Inward/Outward Winding Changeover switch on roll unit is in desired direction
and press Auto Take-up/Pause button.
The Pause lamp, which has been lighted up to this point, turns off, and the Auto Take-up
lamp lights up instead.
The winding preparation is complete. During printing, the winding starts. Before printing, the
winding starts at the same time as the printing.
Important
•
When winding inwardly, loosening of the wound paper can be prevented by pressing the
roll paper with the arm. However, doing so may produce pressure traces on the paper. In
this case, tap the roll unit area of the media information display area and set Paper
retention setting to Release.
136