Owner's Manual

Table Of Contents
66: Incorrect wireless LAN password
Are the camera and the access point set to use the same password for
authentication?
Check upper- and lower-case letters, and make sure the correct password for
authentication is set on the camera.
67: Incorrect wireless LAN encryption method
Are the camera and the access point set to use the same encryption method?
The camera supports the following encryption methods: WEP, TKIP, and AES.
If filtering by MAC address is active, is the MAC address of the camera in use
registered at the access point?
Register the MAC address of the camera used to the access point. The MAC
address can be checked on the [View info] screen ( ).
68: Cannot connect to wireless LAN terminal. Retry from the
beginning.
Did you hold down the access point's WPS (Wi-Fi Protected Setup) button for the
specified period of time?
Hold down the WPS button for the period of time specified in the access point's
instruction manual.
Are you trying to establish a connection near the access point?
Try establishing the connection when both devices are within reach of each other.
69: Multiple wireless LAN terminals have been found. Cannot
connect. Retry from the beginning.
Connection is in progress by other access points in Pushbutton Connection
mode (PBC mode) of WPS (Wi-Fi Protected Setup).
Wait a while before trying to establish the connection.
91: Other error
A problem other than error code number 11 to 69 occurred.
Turn the camera's power switch off and on.
619