User's Manual

21：No address assigned by DHCP server
What to check on the transmitter
On the transmitter, the IP address is set to [Auto setting]. Is this the correct
setting?
• If no DHCP server is used, configure settings after setting the IP addresses to
[Manual setting] on the transmitter ( ).
What to check on the DHCP server
Is the power of the DHCP server turned on?
• Turn on the DHCP server.
Are there enough addresses for assignment by the DHCP server?
• Increase the number of addresses that can be assigned by the DHCP server.
• Remove devices whose IP addresses are assigned by the DHCP server from the
network to reduce the number of addresses in use.
Is the DHCP server working correctly?
• Check the DHCP server settings to make sure it is working correctly as a DHCP
server.
• If applicable, ask your network administrator to ensure that the DHCP server is
working.
What to check on the network as a whole
Does your network include a router or similar device that serves as a gateway?
• If applicable, obtain the network gateway address from your network administrator
and enter it on the transmitter ( , ).
• Make sure that the gateway address setting is correctly entered on all network
devices, including the transmitter.
145