Owner's Manual

•
Creative Zone Modes
• Set the lens focus mode switch to
<AF>.
• Press the < AF > button, then turn
the
<is',> dial.
• Press the
<ttl> button, then look
through the viewfinder.
• Turn the
<iCS3> or <0> dial to
select the AF point.
• You can also use the
<~}> to
select the AF point.
• Pressing
<@ > will switch
between the center AF point and
automatic AF point selection.
• When all the AF points light up,
automatic AF point selection will
take effect.
ONE SHOT (One-Shot AF):
f8=I
""",IlL-~--""------'''------'-'-~~ For still subjects
fOCUS "TI AI FOCUS(AI Focus AF):
en SWitches the AF mode automatically
AI SERVO(AI Servo AF):
For moving subjects
* This drive mode <i (5) > can be set
in all shooting modes.
• Press the
<DRIVE> button, then
turn the
<is',> dial.
0: Single shooting
~H: High-speed continuous
shooting
~: Low-speed continuous
shooting
i ~ : 1a-sec. self-timerl
Remote control*
i ~2: 2-sec. self-timerl
Remote control
~~~~ • Press the <ISO> button, then turn
the
<iCS3> dial.
• ISO 100 to 6400 can be set
in
1/3-stop increments.
• When "A" is selected, the ISO
speed is set automatically. When
you press the shutter button
halfway, the ISO speed setting
will be displayed.
You can change the camera
settings as desired to shoot in
various ways.
The camera automatically sets the shutter speed and aperture
in the same way as the <0> mode.
• Set the Mode Dial to
<P >.
• Set the Mode Dial to <Av>.
• Turn the <iCS3> dial to set the desired
aperture, then focus the subject.
~=~=~~;::::::::~~ II> The shutter speed will be set
automatically.
'-- __ ....:... =;;;;.0 • If the shutter speed display blinks, turn
the < iCS3 > dial until it stops blinking.