Owner's Manual
Table Of Contents
- Instructions
- Camera Firmware
- Conventions used in these instructions
- Safety Precautions
- General Precautions
- Nomenclature
- Attaching and Detaching the Lens
- Setting the Focus Mode
- Setting the Focusing Distance Range
- Control Ring
- SA Control Ring
- Image Stabilizer
- Hand-held Close-up (Macro) Shooting
- Exposure When Taking Close-up (Macro) Shots
- Hood
- Tripod Mount (Sold separately)
- Filters (Sold separately)
- Macro Flash (Sold separately)
- Specifications
ENG-17
Attaching the Tripod Mount
Tripod Mount (Sold separately)
①
③
②
Collar
Lock
knob
1 Open the collar of the
tripod mount
z
Turn the lock knob
counterclockwise until it becomes
loose (about 3 turns)
(①).
z
Pull the knob in the direction of the
arrow (
②
) to release the collar (
③
).
④
Tripod mount
adapter
2 Attach tripod mount to
lens
z
With the collar open, insert the
tripod mount onto the adapter
and close the collar (④).
⑦
⑦
⑤
⑥
3 Fix tripod mount to lens
z
While pulling the lock knob (
⑤
),
insert the end of the open collar until
it reaches its original position (
⑥
).
z
While depressing the lock knob,
turn and tighten it, thus fixing the
mount securely to the lens
(⑦).
When removing the tripod mount, hold the camera and lens and remove the mount following the
above procedure in reverse.
Switching the Orientation of the Image
By loosening the lock knob on the tripod mount you can rotate the camera and the lens to switch the
image in any orientation (vertical, horizontal, etc.). Make sure that the lock knob is tightened after
setting the camera in place.