User's Manual
Table Of Contents
- Contents
- Chapter 1 Introduction
- Chapter 2 Important Safety Instructions
- Chapter 3 Connecting the Scanner
- Chapter 4 Placing Documents
- Chapter 5 Scanning with CaptureOnTouch Lite
- Scanning with CaptureOnTouch Lite
- Starting and Exiting CaptureOnTouch Lite
- Operations for the scanned image edit window
- Setting the scan mode
- Configuration and Functions of the Advanced Settings Dialog Box
- Scan Panel
- Setting Basic Scanning Conditions
- Function Restrictions Depending on Mode Setting
- Setting the output
- Environmental Settings
- Chapter 6 Special Scanning
- Practical Examples
- When you want to delete the images of the blank pages in two-sided documents
- Practical Examples
- When you do not want to scan colored lines and text
- Practical Examples
- When you want to enhance the color red
- Practical Examples
- When you want to enhance contours in images
- Practical Examples
- When you want to make lines or characters in the scanned images thicker
- Practical Examples
- How to produce a picture quality scan
- Practical Examples
- When you want to enhance text that is difficult to read because of factors such as the background of the scanned document
- Practical Examples
- To correct tilted documents and images
- Practical Examples
- When you want to detect multiple pages fed at the same time
- Practical Examples
- When you want to match the orientation of images to the text when scanning a mixture of pages with different text orientations
- Practical Examples
- When you want to rotate the images of a document placed horizontally to correct the orientation
- Chapter 7 Regular Maintenance
- Chapter 8 Detaching and attaching the feed roller and separation pad
- Chapter 9 Updating CaptureOnTouch Lite
- Chapter 10 Troubleshooting
- Chapter 11 Appendix
10
3 Push the section (front cover) at the front of the feed tray to close it.
Supplying Power to the Scanner
The scanner is bus powered by connecting it to a computer with a USB
cable. Power cannot be supplied from a power outlet using an AC adapter,
etc.
Regulations
FCC REGULATIONS (For North America)
Document Scanner, Model 6130200
This device complies with Part 15 of FCC Rules and Industry Canada
licence-exempt RSS standard(s). Operation is subject to the following two
conditions: (1) this device may not cause interference, and (2) this device
must accept any interference, including interference that may cause
undesired operation of this device.
Le présent appareil est conforme aux la partie 15 des règles de la FCC et
CNR d'Industrie Canada applicables aux appareils radio exempts de
licence. L'exploitation est autorisée aux deux conditions suivantes : (1)
l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil
doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d'en compromettre le fonctionnement.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment OFF and ON, the user is encouraged to try to
correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Use of shielded cable is required to comply with Class B limits in
Subpart B of Part 15 of FCC Rules.
Do not make any changes or modifications to the equipment unless
otherwise specified in the manual. If such changes or modifications should
be made, you could be required to stop operation of the equipment.
When not using the scanner, close the scanner's Document
Feed Tray or disconnect the USB cable.
When transporting the scanner, make sure to close the front
cover beforehand. Failure to do so may result in the feed tray
opening and causing the scanner to fall.