Owner's Manual
Table Of Contents
- Advanced User Guide
- Contents
- Introduction
- Getting Started
- Wireless Flash Photography
- Wireless Settings
- ETTL: Fully Automatic Wireless Flash Photography
- Advanced Shooting with Fully Automatic Wireless Flash
- Using Multiple Senders
- ETTL: Wireless Multiple-Flash Photography with Flash Ratio
- M: Wireless Multiple-Flash Photography with Manual Flash Output
- Gr: Shooting in a Different Flash Mode for Each Group
- Clearing Transmitter Settings
- Test Firing from Receivers
- Remote Release from Receivers
- Setting Transmitter Functions from the Camera
- Customizing the Transmitter
- Reference
- Basic Instructions
- Warranty
3.
Press the <
> button.
[Flash function settings] is displayed on the camera screen.
Note
All transmitter features are configured from this camera menu.
The transmitter's settings are stored even when you detach it from the camera. The
settings are maintained when you reattach the transmitter.
You can set the camera to beep when the receiver is fully charged (C.Fn-20).
The transmitter is powered by the camera.
Auto Power Off
The unit will turn off automatically 5 min. after the camera's auto power off feature is
activated, if no operation is performed. To wake it, either wake the camera or press the
< > button on the ST-E10. Note that during the time until the ST-E10 goes off
automatically, it will continue to consume camera battery power.
16