Owner's Manual
Table Of Contents
- Advanced User Guide
- Contents
- Introduction
- Getting Started
- Wireless Flash Photography
- Wireless Settings
- ETTL: Fully Automatic Wireless Flash Photography
- Advanced Shooting with Fully Automatic Wireless Flash
- Using Multiple Senders
- ETTL: Wireless Multiple-Flash Photography with Flash Ratio
- M: Wireless Multiple-Flash Photography with Manual Flash Output
- Gr: Shooting in a Different Flash Mode for Each Group
- Clearing Transmitter Settings
- Test Firing from Receivers
- Remote Release from Receivers
- Setting Transmitter Functions from the Camera
- Customizing the Transmitter
- Reference
- Basic Instructions
- Warranty
Wireless Flash Photography
This chapter describes how to shoot with wireless flash using radio transmission.
See the system map ( ) for the accessories required for radio transmission wireless flash
shooting.
Caution
Operations described in this chapter are not available when the camera is set to
Basic Zone shooting modes. Set the camera's shooting mode to < > < >
< > < > < > <bulb( )> (Creative Zone).
Note
The ST-E10 attached to the camera is referred to as a “sender,” and other
Speedlites controlled wirelessly are referred to as “receivers.”
• Wireless Flash Photography
• Wireless Settings
• ETTL: Fully Automatic Wireless Flash Photography
• Advanced Shooting with Fully Automatic Wireless Flash
• Using Multiple Senders
• ETTL: Wireless Multiple-Flash Photography with Flash Ratio
• M: Wireless Multiple-Flash Photography with Manual Flash Output
• Gr: Shooting in a Different Flash Mode for Each Group
• Clearing Transmitter Settings
• Test Firing from Receivers
• Remote Release from Receivers
17