Owner's Manual
Table Of Contents
- Advanced User Guide
- Contents
- Introduction
- Getting Started
- Wireless Flash Photography
- Wireless Settings
- ETTL: Fully Automatic Wireless Flash Photography
- Advanced Shooting with Fully Automatic Wireless Flash
- Using Multiple Senders
- ETTL: Wireless Multiple-Flash Photography with Flash Ratio
- M: Wireless Multiple-Flash Photography with Manual Flash Output
- Gr: Shooting in a Different Flash Mode for Each Group
- Clearing Transmitter Settings
- Test Firing from Receivers
- Remote Release from Receivers
- Setting Transmitter Functions from the Camera
- Customizing the Transmitter
- Reference
- Basic Instructions
- Warranty
< > Lamp
You can determine the connection status from the state of the < > lamp.
Status Description Action
Lit Connected –
Off Not connected Check the channel and ID
Blinking
Too many units Do not exceed 16 senders and receivers, combined
Error Restart the sender and receiver
Caution
Receivers will not fire unless the sender and receiver channels match. Set both to
the same number, or set both to “AUTO.”
Receivers will not fire unless the sender and receiver wireless radio IDs match. Set
to the same number.
28