Owner's Manual
Table Of Contents
- Advanced User Guide
- Contents
- Introduction
- Getting Started
- Wireless Flash Photography
- Wireless Settings
- ETTL: Fully Automatic Wireless Flash Photography
- Advanced Shooting with Fully Automatic Wireless Flash
- Using Multiple Senders
- ETTL: Wireless Multiple-Flash Photography with Flash Ratio
- M: Wireless Multiple-Flash Photography with Manual Flash Output
- Gr: Shooting in a Different Flash Mode for Each Group
- Clearing Transmitter Settings
- Test Firing from Receivers
- Remote Release from Receivers
- Setting Transmitter Functions from the Camera
- Customizing the Transmitter
- Reference
- Basic Instructions
- Warranty
ETTL: Fully Automatic Wireless Flash Photography
Autoflash Using One Receiver
Autoflash Using Multiple Receivers
This section describes basic fully automatic wireless shooting with the ST-E10 attached to
the camera as a sender to control a flash unit (receiver) wirelessly.
Autoflash Using One Receiver
1.
Set the flash unit as a receiver.
For instructions on configuring receiver settings, refer to the instruction
manual of the flash unit.
Set A, B, or C as the firing group. It will not fire if set to D or E.
2.
Check the channel and ID.
If the transmission channels and wireless radio IDs of the sender unit
and receiver unit are different, set them to the same settings ( ).
29