Owner's Manual
Table Of Contents
- Advanced User Guide
- Contents
- Introduction
- Getting Started
- Wireless Flash Photography
- Wireless Settings
- ETTL: Fully Automatic Wireless Flash Photography
- Advanced Shooting with Fully Automatic Wireless Flash
- Using Multiple Senders
- ETTL: Wireless Multiple-Flash Photography with Flash Ratio
- M: Wireless Multiple-Flash Photography with Manual Flash Output
- Gr: Shooting in a Different Flash Mode for Each Group
- Clearing Transmitter Settings
- Test Firing from Receivers
- Remote Release from Receivers
- Setting Transmitter Functions from the Camera
- Customizing the Transmitter
- Reference
- Basic Instructions
- Warranty
ETTL: Wireless Multiple-Flash Photography with
Flash Ratio
Autoflash with Two Receiver Groups
Autoflash with Three Receiver Groups
Group Control
Autoflash with Two Receiver Groups
You can adjust the lighting balance (flash ratio) with receivers separated into 2 groups, A
and B.
The total (sum) of light from firing groups A and B is automatically controlled to a achieve
standard exposure.
1.
Set the firing group of the receivers.
Set this manually on each receiver.
Set 1 receiver to < > and the other to < >.
For instructions on configuring receiver settings, refer to the instruction
manual of the flash unit.
43