Owner's Manual
Table Of Contents
- Advanced User Guide
- Contents
- Introduction
- Getting Started
- Wireless Flash Photography
- Wireless Settings
- ETTL: Fully Automatic Wireless Flash Photography
- Advanced Shooting with Fully Automatic Wireless Flash
- Using Multiple Senders
- ETTL: Wireless Multiple-Flash Photography with Flash Ratio
- M: Wireless Multiple-Flash Photography with Manual Flash Output
- Gr: Shooting in a Different Flash Mode for Each Group
- Clearing Transmitter Settings
- Test Firing from Receivers
- Remote Release from Receivers
- Setting Transmitter Functions from the Camera
- Customizing the Transmitter
- Reference
- Basic Instructions
- Warranty
M: Wireless Multiple-Flash Photography with Manual
Flash Output
MULTI: Stroboscopic Flash
This section describes wireless multiple-flash shooting in manual flash mode. You can set
the flash output in a range from full 1/1 output to 1/8192 output in 1/3-stop increments for
each firing group. All settings are configured on the sender unit.
1.
Press the <
> button.
2.
Select [Flash mode].
3.
Set the flash mode to [Manual flash].
Select [Manual flash] and then [OK].
50